'voRia' pid='266' dateline='1236526206' wrote:
Just checked, the linux-backports-modules package in jaunty is based on snapshot 2009-03-03 of ath5k module drivers.
I'm glad it works for you now
When you'll check the wlan in your city's library, let me know if issues are gone there too!
Those good days I could play my nc10 in local library Linux-unfriendly environment.
But according to development state of ath5k things are going worse and worse: Using Jaunty and latest voria built backports-modules, a) the network manager must be commanded several times to start wlan and b) the speed is only 40k...80k. But Network Manager reports 54M for wlan. Pretty useless!
NOTE: nc10 works fine in all other wlan environments I tested, and wlan network is found immediately. But this stupid Library wlan?
Iwconfig reports in library:
lo no wireless extensions.
eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11bg ESSID:"Kirjasto"
Mode:Managed Frequency:2.437 GHz Access Point: 00:90:0E:01:62:6D
Bit Rate=54 Mb/s Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Link Quality=56/70 Signal level=-54 dBm Noise level=-94 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
pan0 no wireless extensions.